HELICOMMAND RIGID SETUP IN MY VARIO LAMA TURBINE
Helicommand Rigid Software: http://www.helicommand.com/index.php?option=com_phocadownload&view=category&id=2%3Am-serie-helicommand&Itemid=106&lang=en
Comments to the tab in the program:
RC&Trim – No changes,
Tail gyro – Nothing here since i am using the Futaba 401 gyro
Rigid – It was here i changed the settings to a lower point than the default. I started very low and then just up to were it is now.
Rigid gain ail, elev, agility and direct control portion.
Hor + Pos – Not in use
Installation in the model